Check Engine Light Illuminated with DTC’s P0106, P0046, P20EE, P249D, and/or P249E Set – 2019 Chevrolet Colorado & GMC Canyon

SEOCONTENT-START

Service Bulletin Bulletin No.: 19-NA-127
Date: June, 2019
INFORMATION
Subject: Check Engine Light Illuminated with DTC’s P0106, P0046, P20EE, P249D, and/or
P249E Set
Brand: Model:
Model Year: VIN: Engine: Transmission:
from to from to
Chevrolet Colorado 2019 2019
LWN All
GMC Canyon 2019 2019
Involved Region or Country North America, N.A. Export Regions
Additional Options (RPOs)
Condition
Some customers may comment on a check engine light on the Driver Information
Center (DIC) illuminated.
Some technicians may find one or more of the following DTCs set in the Engine Control
Module (ECM):
• P0106: Manifold Absolute Pressure (MAP) Sensor Performance
• P0046: Turbocharger Boost Control Position Performance
• P20EE: NOx Catalyst Efficiency Below Threshold
• P249D: Closed Loop Reductant Injection Control At Limit – Flow Too Low
• P249E: Closed Loop Reductant Injection Control At Limit – Flow Too High
Cause The cause of the condition may be an ECM software anomally.
Correction
Important: For vehicles registered in Canada, please see field action N192220100.
Check the Engine Control Module (ECM) for the latest update:
• If the software version is not the latest update, reprogram the ECM following the
Service Procedure below.
• If the ECM has already been updated, continue with SI diagnostics for the codes set in
the ECM.
Service Procedure
If programming the ECM then refer to K20 Engine
Control Module: Programming and Setup in SI.
Note: Stable battery voltage is critical during
programming. Any fluctuation, spiking, over voltage or
loss of voltage will interrupt programming. Install a GM
Authorized Programming Support Tool to maintain
system voltage. Refer to for further information. If not
available, connect a fully charged 12 V jumper or
booster pack disconnected from the AC voltage supply.
DO NOTconnect a battery charger
Parts Information
No parts are required for this repair.
Page 2 June, 2019 Bulletin No.: 19-NA-127
Warranty Information
For vehicles repaired under the Powertrain coverage,
use the following labor operation. Reference the
Applicable Warranties section of Investigate Vehicle
History (IVH) for coverage information.
Labor Operation Description Labor Time
*2886308 Engine Control Module Reprogramming with SPS 0.3
*This is a unique Labor Operation for Bulletin use only.
*To avoid warranty transaction rejections, the SPS Warranty Claim Code must be entered when submitting this transaction.
When more than one Warranty Claim Code is generated for a control module programming event, it is required to document all
Warranty Claim Codes in the Correction field on the Job Card. Dealers must only enter one code in the “SPS Warranty Claim
Code” field on the transaction, otherwise the transaction will reject.
Warranty Claim Code Information Retrieval
If the SPS Warranty Claim Code was not recorded on
the Job Card, the code can be retrieved in the SPS
system as follows:
• Open TIS on the computer used to program the
vehicle.
• Select and start SPS.
• Select Settings.
• Select the Warranty Claim Code tab.
The VIN, Warranty Claim Code and Date/Time will be
listed on a roster of recent programming events. If the
code is retrievable, dealers should resubmit the
transaction making sure to include the code in the SPS
Warranty Claim Code field.
Version 1
Modified Released June 11, 2019

SEOCONTENT-END