NHTSA ID Number: 10114279
Manufacturer Communication Number: PI1329
Summary
This preliminary bulletin provides a procedure to replace the ignition cylinder if found that it has excessive wear which can cause the vehicle to power up or start when the key is put in the ignition with out turning it.
14 Affected Products
Vehicles
Parts
| Cylinder Kit, Ignition (Uncoded)
Includes Tumblers and Springs | 1 | 20766607
General Motors 20766607, Ignition Lock Cylinder
|
SEOCONTENT-START
Bulletin No.: PI1329
Date: October, 2014
| Subject: | Vehicle Power Modes or Starts by Itself When Key is Put in the Ignition or Left in the Ignition in the Off Position |
| Models: | 2013-2015 Buick Encore |
| 2012-2015 Chevrolet Cruze |
|
| 2012-2015 Chevrolet Sonic |
|
| 2013-2015 Chevrolet Trax |
Condition/Concern
Customer may comment that when they put their key in the ignition or when they leave their key in the ignition, the vehicle will power up that may include cranking and/or crank and start of engine for a brief period of time. Key in warning chime will also be inoperative. May also manifest as a low or dead battery after sitting for long periods of time with key left in ignition.
Note: Manual Transmission equipped vehicles have a clutch activation safety switch that will inhibit the starter operation unless the clutch is engaged (pressed in). Manual transmission vehicles may experience the power moding, but will not experience the cranking or starting concern with the clutch in the released position due to this safety device.
The ignition cylinder actuator which is used to activate the key reminder circuit may wear excessively during use. If sufficient wear occurs, there will be limited travel of the trigger and minimal contact force between the key reminder circuit terminals. This minimal contact may cause a degradation in the voltage seen by the BCM which may be interpreted by the BCM as a command to power mode or crank.
Recommendation/Instructions
Replace the ignition cylinder and verify that key in warning chime is working properly after repair. Refer to Ignition Lock Cylinder Replacement in SI. Charge the battery as required.
Parts Information
| Part Number | Description | Qty |
| 20766607
General Motors 20766607, Ignition Lock Cylinder
|
Cylinder Kit, Ignition (Uncoded) Includes Tumblers and Springs | 1 |
Warranty Information
For vehicles repaired under the Bumper-to-Bumper coverage (Canada Base Warranty coverage), use the following labor operation. Reference the Applicable Warranties section of Investigate Vehicle History (IVH) for coverage information.
| Labor Operation | Description | Labor Time |
| 5480098*
(Encore, Trax) |
Replace Ignition Cylinder | 0.4 hr |
| 5480098*
(Cruze, Sonic) |
Replace Ignition Cylinder | 0.5 hr |
| *This is a unique Labor Operation for Bulletin use only. It will not be published in the Labor Time Guide. | ||
Additional SI Keywords:
Unwanted, Crank
SEOCONTENT-END
Bulletin No.: PI1329
Date: October, 2014
To View or Download this Document Click Here
Bulletin No.: PI1329
Date: October, 2014
To View or Download this Document Click Here
- Authentic Replacement Design: Replacement keys that look and function like the original
- Self-Programming Capability: You can do this yourself using provided instructions
- Wide Compatibility Range: Replaces ID 46 CIRCLE +, B111-PT, B112-PT, GMX-100C, 5903089, G0001-G3631, 692931, TP12GM37P, GMX380CP
- Verification Required: Please read all details to confirm your ordering the proper part
- Transponder Key Technology: Features uncut transponder key compatible with ID 46 Circle + for secure vehicle ignition
- Replacement: For Remote fob P/N: 15871576,B111-PT,GMX-100C
- Programming Methord: The key is user-programmable with one working key, but needs to be cut by a professional locksmith or dealer
- Assembly & Testing: 2 Fob Key with Electronics board are included and pre-installed; Each item has been tested before shipping
- Instructions for use: It's a 100% Brand New blank key, which needs to be programmed and cut before use; if don't know how to do, contact us please
- Purchase Instructions: Make sure that your OEM information (include part number and chip type) is the same as ours and If you don't know, please consult your dealership or us
- Pair Strattec #595311 OE #01154606 with Pair Strattec #595198 OE #01154607
- 2 "E" Primary Square Ignition Key Blanks + 2 "H" Secondery Oval Doors/Trunk Key Blanks
- Brand:Strattec, Country/Region Of Manufacture:United States
- Manufacturer Part Number: 595198, 595311, Surface Finish: Hard Rubber GM Logo
- Fits Many GM Vehicles 1969 1973 1977 1981 & 1991-1995
- Pair Strattec #320404 OE #01154606 Pair with Strattec #320405 OE #01154607
- 2 "E" Primary Square Ignition Key Gaps + 2 "H" Second Oval Doors/Trunk Key Gates
- Brand: Strattec, Country/Region of Manufacture: United States
- Manufacturer Part Number: 320404, 320405, Surface Finish: OEM "Mined Part" GM Wrenches
- Fits Most GM Vehicles 1969 1973 1977 1981 & 1991-1995
- COMPATIBILITY: This Ignition Key Replacement Is Compatible with Chevrolet 2010-2016 Camaro, 2014-2017 PPV, 2015-2021 Colorado, 2011-2016 Cruze, 2010-2019 Equinox, 2014-2019 Impala, 2014-2016 Malibu, 2014-2021 Silverado, 2012-2018 Sonic, 2016-2018 Spark, 2015-2021 Suburban, 2015-2021 Tahoe, 2013-2019 Trax
- REPLACEMENT: This Key Repalcement Compatible With Part Number: B119-PT, HU100, PCF7937EA, B119, B116 (7937EA). Compatible With Chip: 46. Please Check Our Product Description and Vehicle Fitment Tool for Full Compatible Vehicles List. This New Blank Key Replacement Is Compatible with Buick 2014-2021 Encore, 2010-2016 Lacrosse, 2011-2017 Regal, 2012-2017 Verano, GMC 2015-2021 Canyon, 2016-2019 Cascada, 2014-2021 Sierra, 2010-2021 Terrain, 2015-2021 Yukon
- PROGRAMMING: It Requires One Working Key to Self-Programming. Uncut Key Blade Needs to Be Cut By Locksmith or Dealership
- PACKING LIST: 1 X 100% Brand New Uncut Transponder Blank Key Repalcement.
- Purchase Instructions: Make sure that your OEM information (include part number and chip type) is the same as ours.
This product presentation was made with AAWP plugin.